Case studies / Partner project

Visual clamping with Teledyne: inspect a part wherever it lies

An operator lays a part on the table without a fixture. A Teledyne Perciva 5D camera locates it, LumiScan VGR adjusts the measurement path, and a cobot carries a Z-Trak profiler along that path.

Partner demonstration at VISION 2026 in Stuttgart

The workstation and the loose part at the Teledyne booth. Footage by HD Vision Systems, VISION 2026.

The task

A programmed path assumes the part is at a known position. If the operator sets it down at an angle, the sensor must still reach the same features.

The solution

The camera takes a new measurement after placement. LumiScan VGR uses the detected position and orientation to move the predefined path with the part. The cobot can then guide the profiler over the intended features.

The result

The partners demonstrated a measurement pass on a freely placed part without a dedicated locating fixture.

A similar task?

Tell us what you want to automate – we’ll tell you whether and how LumiScan solves it.

Discuss your application Building cells? For integrators & OEMs